Description
Bath with selector and digital temperature reading. For temperature from + 5 ° C up to 200 ° C,
stability + 0.1 ° C, setpoint error + 2 ° C, resolution 0.1 ° C.
Bath Safety Digiterm-200 27
– DIN 12879.2 standard. – Adjustable safety thermostat with manual reset. – Alarm of
overheated. – Level float which cuts off the heating in the event of a lack of liquid. – Alarm of
mains voltage failure.
Characteristics of the Digiterm-200 27 bath
Temperature control by microprocessor which, thanks to an LCD screen, allows you to configure and
view the following parameters: – Upper and lower temperature limit. – Selection in
° C or ° F. – Screen resolution 0.1 °. – External probe. – Overheating alarm limits. Calibration. –
Low liquid level indication. Temperature sensor by Pt 100 thermoresistor.
Heating elements in stainless steel. Long lasting special INCOLOY, resistant to corrosion and
high temperature. Circulation pump with adjustable flow rate for agitation and external circulation.
(Polarimeters, refractometers, viscometers, etc.). Refrigeration coil to be able to regulate
ambient temperatures by connection to mains water. Connection for temperature probe
external Pt 100. RS-232 output for reading and printing parameters by computer. Body
exterior covered in epoxy with all parts in contact with the liquid in stainless steel. AISI 304.
With side handles and drain valve.
Digiterm-200 bath control panel 27
General start switch. Parameter display LCD screen. Selection key
configuration. Settings button. SET value increase button. Key
decrease in SET value. On – Off button.
Additional information on Digiterm-200 27
Date of manufacture
2007
